Table of Contents
Advertisement
Antenna Connections
Combination
VHF/UHF Antennas
300 ohm
Flat Wire
300 to 75
ohm Adapter
Connecting an Outdoor Antenna
For the best reception, we recommend you use an outdoor antenna.
Severely weathered antennas and antenna cables can reduce the signal quality. Check antenna and
antenna cables condition before making connections. Any service center can explain the various outdoor
antennas available to you.
300 Ohm Flat Wire
1. Connect the 300 ohm flat wire to screws on the
300 ohm to 75 ohm adapter.
2. Push the end of 300 ohm to 75 ohm adapter
into 75 ohm antenna jack.
Note: 300 ohm to 75 ohm adapter is sold separately.
Connecting a CATV Cable
If you subscribe to a CATV system (cable service), change the antenna connection as described below.
1.
75 ohm
Antenna Jack
1. Remove the 300 to 75 ohm adapter or the cable from the set if attached.
2. Connect the CATV cable (75 ohm coaxial cable) to the 75 ohm antenna jack.
TV rear
75 ohm
75 ohm
Antenna
Coaxial
Jack
Cable
75 ohm
CATV Cable
300 to 75 ohm
Adapter
300 to 75
ohm Adapter
75 Ohm Coaxial Cable
1. Connect the 75 ohm coaxial cable directly to
the 75 ohm antenna jack.
2.
29
300 ohm Flat Wire
75 ohm CATV Cable
from cable TV source
Advertisement
Table of Contents
