Table of Contents
Advertisement
R
4.8 ENGAGING THE DECK DRIVE
(CUTTER BLADES)
1. Set the throttle at about 3/4 speed. Do not attempt to
engage the deck drive at high speed as this shortens
the electric clutch life — use only moderate engine
speed when engaging the deck drive.
DANGER
ROTATING BLADES
NEVER PUT YOUR HANDS INTO THE DISCHARGE
CHUTE FOR ANY REASON!
Shut off the engine and remove the key and
only then use a stick or similar object to remove
material if clogging has occurred.
2. Engage the deck drive by pulling out on the yellow
switch, located on the instrument panel, to the
engage position. See Figure 4-4.
Figure 4-4. Cutter Engage Switch
- NOTE -
A squealing noise may be heard when engaging
or disengaging the deck drive. It is caused by the
electric clutch plates meshing as the mower comes
up to speed. This is normal.
3. To disengage the deck drive, push the switch in to
the disengage position.
4. Always operate the engine at full throttle to properly
maintain cutting speed. If the engine starts to lug
down, reduce the forward speed and allow the
engine to operate at maximum RPM.
PULL UP TO ENGAGE
PUSH DOWN TO DISENGAGE
4.9 HILLSIDE OPERATION
WARNING
DO NOT operate on steep slopes. To check a
slope, attempt to back up it (with the cutter deck
down). If the machine can back up the slope
without the wheels slipping, reduce speed and
use extreme caution. Under no circumstances
should the machine be operated on slopes
greater than 15 degrees. See Figure 2-4, page
11 to determine approximate slope of area to be
mowed. ALWAYS FOLLOW OSHA APPROVED
OPERATION.
1. This mower has been designed for good traction
and stability under normal mowing conditions.
However, caution must be used when traveling on
slopes, especially when the grass is wet. Wet grass
reduces traction and steering control. The Roll-Over
Protection System is standard equipment for this
machine. See Section 2.6, page 7 of this manual for
further details.
2. Stay at least 2 cutting widths away from drop-offs,
ditches, retaining walls, water, avoid any slope
exceeding 15-degrees, and do not mow under trees
on slopes with the roll bar down.
3. To prevent tipping or loss of control, do not start or
stop suddenly, avoid unnecessary turns and travel
at reduced speed. If tires lose traction, disengage
blades and proceed slowly off the slope.
4. Avoid sudden starts when mowing uphill. Sudden
starts may cause the machine to tip backwards.
5. Loss of traction may occur when traveling down hill.
Weight transfers to the front of the machine and
may cause the drive wheels to slip causing loss of
braking or steering.
6. Keep tires properly inflated.
4.10 PARKING THE MOWER
1. Park the machine on a flat, level surface only. Do not
park the machine on an incline.
2. Place the steering control levers in the neutral
position.
3. Disengage the cutter blades.
4. Slow the engine to idle speed.
22
Section 4
Advertisement
Table of Contents
