Installation On A Gearbox; Completion Of Assembly - Bosch rexroth A36VM Instruction Manual

32/54 A36VM | Installation
For attachment via gear
wheel or helical gear shaft
Bosch Rexroth AG, RE 91650-01-B/2021-07-19
7�4�5 Installation on a gearbox
The following describes how to install the axial piston unit on a gearbox.
After installing on a gearbox, the axial piston unit is covered and is difficult to access:
▶ Before installing, make sure that the spigot diameter centers the axial piston unit
(observe tolerances) and that no excessive axial or radial forces are acting on the
drive shaft of the axial piston unit (installation length).
▶ Protect the drive shaft against frictional corrosion by ensuring permanent
lubrication.
▶ Fasten the axial piston unit at the installation location.
No gearing forces higher than the permissible axial and radial forces should act on
the shaft; if necessary, support the gear wheel at the gearbox output separately.
7�4�6 Completion of assembly
1� Remove any installed transport screws.
CAUTION! Operation with protective plugs!
Operating the axial piston unit with protective plugs may result in injury or damage
to the axial piston unit.
▶ Before commissioning, remove all protective plugs and replace them with suitable,
pressure-resistant, metal threaded plugs or connect the appropriate lines.
2� Remove the transport protection.
The axial piston unit comes with protective covers (1) and protective plugs (2).
(1) and (2) are not pressure-resistant and have to be removed prior to
connection. Use a suitable tool for this to prevent damage to the sealing and
functional surfaces. If sealing or functional surfaces are damaged, contact your
Bosch Rexroth service partner or the service department of the manufacturer's
plant of the axial piston unit.
1
Fig� 9: Removing transport protection
1 Protective covers
2 Protective plugs/threaded plugs
2