Advertisement
2 SETUP
4
–
Together with an assistant, take the vehicle off the pallet.
–
Position the vehicle on a lift stand.
–
Check the vehicle for transport damage.
Info
The procedure in the event of transport damage is
described in the Customer Service Manual.
(350 XC‑F US Factory Edition)
–
Remove the front wheel. (
V02693-01
–
Mount the brake disc guard.
–
Install the front wheel. (
F03724-01
–
Remove cable ties on the side cover and remove film from the
handlebar.
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
I00078-10
–
Change the handlebar if the handlebar is damaged
or bent.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
Do not kink the cables or lines.
–
Position the handlebar clamp.
–
Mount screws
–
First bolt the handlebar clamp with screws
higher side of the handlebar supports so that both parts touch.
–
Tighten screws
Guideline
Screw, handlebar
clamp
Info
The markings on the handlebar should be at the center
of the handlebar clamps.
p. 10)
Info
Read the accompanying KTM PowerParts
instructions.
Align the brake disc guard so that the distances
are the same size.
p. 11)
1
, but do not tighten yet.
1
evenly.
M8
20 Nm (14.8 lbf ft)
1
onto the longer,
Advertisement
