Table of Contents
Advertisement
HEAT RUN MODE FUNCTION
Heat Run Mode
1)
To activate
Be sure to load the disc previously.
Press the disc holder open/close button (4 OPEN/CLOSE) to cancel Heat Run Mode.
Never push the PAUSE button.
Operation
Error Message
When the system error occurs while in Heat Run mode, the following error message will display on the Track No. indicator and
stops operation.
1.E1
At the time of Focus Servo does not activate.
2.E2
When unable to detect synchronous pattern however the disc is in rotating. (GFS does not drive.)
3.E3
No synchronous pattern can be detected while in Play mode. (No GFS drives.)
4.E4
When TOC is unreadable in despite of servo is activated.
5.E5
In case of loader malfunctions. (Unable to turn on the switch.)
6.E6
The inner circle switch of Pick-up does not turn off.
7.E7
The inner circle switch of Pick-up does not turn on.
* Also, displays the number of operation up to this time on the Time (Min.) indicator.
Advertisement
Table of Contents
