Table of Contents
Advertisement
3-2
ERROR CODES
The error codes, their meanings, and the recovery procedures are as follows:
Error
Code
Meaning
0000
You have pressed the Help key; however, either no error code was
displayed or the error was issued by a program that does not support
the Help key.
To recover, press the Error Reset key. Then continue entering
information or refer to the meaning for the previous error code
displayed and do the recovery procedure listed.
0001
The host system or 5251 Model 2 or 12 could not keep up with the
rate at which you entered information and the last characters you
entered were not recognized.
To recover, press the Error Reset key and continue entering
information.
0002
The system or 5251 Model 2 or 12 received a key code that is not
valid and therefore does not recognize which key you pressed.
To recover, press the Error Reset key and try to continue entering
data. If the error cannot be reset or still occurs, contact the IBM 5291
service representative and report the problem.
0003
You have pressed the Cmd key, but the next key you pressed was not
one of the command function keys.
To recover, press the Error Reset key and continue by using the
correct keys.
0004
You have attempted to enter data into a field that does not allow
keyboard input. This field is defined as an
1/0
feature field.
To recover, press the Error Reset key.
0005
You have attempted to enter data; however, the cursor is not in an
input field. Data cannot be entered in a protected area of the display.
To recover, press the Error Reset key and move the cursor to a valid
input field.
0006
After pressing the Sys Req/ Attn key and prior to pressing the
Enter
I
Rec Adv key or the Error Reset key, you pressed a key that is
not valid.
To recover, press the Error Reset key and use a valid key sequence.
Advertisement
Table of Contents
