Volume; Res. Moisture Display; Visibility Parameters; Display Off Status - Miele PDR 914 Operating And Installation Instructions

Supervisor level

Volume

The volume for various sounds can be changed.
The volume can be changed for the following tones:
- Finish tone
The finish tone signals the end of the drying program.
- Keypad tone
-
Welcome tone
-
Fault alarm
The fault tone signals a fault and can be switched off. The volume of the fault tone cannot
be adjusted.

Res. moisture display

In addition to displaying the drying level, the residual moisture can also be indicated as a
percentage.
- Factory default: Without % value
-
With % value

Visibility parameters

Various parameters are offered/displayed when a program is selected. You can decide
which parameters should not be displayed. These parameters can then not be edited dur-
ing program selection.
-
Residual moisture
- Duration
-
Low temperature
-
Anti-crease
- Load size
-
Drying temperature

Display off status

The display switches off to save energy; only the Start/Stop sensor control flashes slowly.
You can change this setting.
Changing this setting leads to increased energy consumption.
- Off
No switching off
-
On (10 min.) Not curr.prog.
The display will remain on while the program is running but will go out 10 minutes after
the end of the program.
-
Logo (10 min.) Not curr.prog.
The display will remain on while the program is running but the logo will light up 10 min-
utes after the end of the program.
- Factory default:
On after 10 min.
The display is switched off after 10 minutes.
32