Yamaha UD-Stomp User Manual page 8

Nomenclature
When the knob is rotated fully to the left (oFF) the
filter is OFF. Rotate the knob to the right to lower
the cut off frequency.
!3 FEEDBACK Control
Sets the how many times the delay will repeat.
!4 TAP Control
Sets the timing for when the delayed sound is taken
from the delay loop.
The value of the parameter is expressed as a per-
centage of the delay time setting.
!5 SPEED Control
Sets the speed of the modulation.
When multiple Effect Bands are Synced together,
this knob adjusts the phase angle.
!6 DEPTH Control
Sets the intensity of the modulation.
!7 PAN Control
Sets the position of the delay within the stereo field.
G Footswitch Section
@2 Footswitches 1, 2, 3
These are used to select a patch (1, 2, 3) in the
currently selected Group/Bank. The lamp for the
selected patch number will light. Pressing the
Footswitch that has its lamp lit will switch the effect
OFF as well as the Footswitch's lamp.
Depending upon the BANK switch setting, these
switches can also be used to select the patch's Area/
Group/Bank, set the Tap Tempo, and for the Sam-
pling function.
* When the effect is switched OFF with the Footswitches 1, 2
or 3, the delayed sound up to that point will remain. When
the BYPASS switch is pressed to bypass the effect, the delay
sound will be muted momentarily.
8
!8 Delay Level Control (LEVEL)
Sets the output level of the delay.
* Rotating the knob fully to the left (
Controllers !9 - @1 listed below are global pa-
rameters for Effect Bands 1-8. They can be
set at any time, even if no Effect Bands are
selected.
!9 EFFECT LEVEL Control
Sets the overall level of the signal sent to the effect.
@0 DIRECT LEVEL/DIRECT PAN Control
Sets the output level of the direct sound.
Hold the FUNCTION button and rotate this knob to
set the stereo position of the direct sound.
@1 OUTPUT Level Control
Controls the signal level that is sent from the UD-
Stomp's output jack (OUTPUT, PHONES).
@2
@3 Bank Switch (BYPASS, BANK, TAP TEMPO)
• Press and release the switch quickly (BYPASS):
All Effect Bands are bypassed leaving only out-
put of the direct sound. When the Bypass is switch
ON, the lamp lights.
* In the bypass mode, the input signal from the instrument is
sent directly to the output (DIRECT LEVEL and DIRECT PAN
settings will have no effect).
• Hold the switch until all footswitch lamps (1-3)
light (BANK): Use Footswitches 1-3 to select an
Area/Group/Bank. (→ page 20)
• Hold the switch until "
display (TAP TEMPO): Tap the Footswitch set
the delay time to the tempo at which the footswitch
is tapped. The Loop Sampling Function is also
available. (→ page 22)
0. 0
) mutes the delay sound.
@3
tAP
" appears in the