Connections; I Connecting The Power; I Connecting The Ud-Stomp - Yamaha UD-Stomp User Manual

Connections

Before making any connections to any of the UD-Stomp's INPUT and/or OUTPUT jacks,
make sure that the power on the UD-Stomp and all other devices is turned OFF to prevent
electrical shock or damage to the devices.

I Connecting the Power

Use the supplied power adaptor (AC-10) to supply
power to the UD-Stomp.
1. Make sure the UD-Stomp's Power Switch
(STAND-BY) is in the OFF (
2. Connect the power adaptor's plug to the AC IN
jack on the UD-Stomp.
3. Connect the power adaptor to an electric outlet.
OFF ( )
Electrical
Outlet
Only use the supplied AC-10 adaptor to
power the unit.
Using another adaptor may result in dam-
age, overheating or fire, which can be
very dangerous.
Make sure to use the recommended AC
voltage as indicated on the power adap-
tor.
The supplied power adaptor AC-10 is de-
signed specifically for use with the UD-
Stomp. Never use this adaptor with any
other device.
10
) position.
Supplied AC
Adaptor AC-10

I Connecting the UD-Stomp

Since the UD-Stomp is a delay effect, it should be
connected to the end of the effect chain when used
with other effects. If the guitar amplifier or mixer you
are using is equipped with a Send/Return circuit,
we recommend that the UD-Stomp be connected to
these jacks.
The Input Level switch should be set according to
the output level of the device connected to the UD-
Stomp (set to LOW if the device's output level is
high, set to HIGH if the output is low).
Also, for maximum effect, connect the OUTPUT
jacks to a stereo system.
When connecting to a monaural device, make sure
you use the OUTPUT's L/MONO jack.
G Connecting to the Effect Send and Re-
turn circuit
INPUT
EFFECT
SEND
Instrument
Guitar Amplifier, etc.
G Connecting at the end of an effects chain
Distortion, etc.
Instru-
ment
INPUT
UD-Stomp
Power Amplifier & Speaker
OUTPUT
L/MONO R
UD-Stomp
EFFECT
RETURN
L R
OUTPUT
L/MONO R
INPUT
L R