Display Messages - Yamaha S-80 Owner's Manual

Display Messages

Message
<< ! MIDI buffer full.
<< ! MIDI data error.
<< ! MIDI checksum error.
<< ! Change internal battery.
<< ! Card full.
<< ! File not found.
<< ! Bad card.
<< ! Card not ready.
<< ! Card unformatted.
<< ! Card write protected.
<< ! Illegal card.
<< ! File already exists.
<< ! Illegal file.
<< ! Illegal file name.
<< ! Read only file.
<< ! Can't make "EXT" file.
<< ! Can't make directory.
<< ! Too deep directory.
<< ! Unknown file format.
<< ! Bulk protected.
<< ! Device number is off.
<< ! Device number mismatch.
<< ! Multi plugin in slot 1.
<< ! Effect plugin in slot 2.
<< ! Plugin1 communication error.
<< ! Plugin2 communication error.
<< ! Plugin1 type mismatch.
<< ! Plugin2 type mismatch.
<< ! PLG100 not supported.
<< Executing...
<< Now working...
<< Now loading...
<< Now saving...
<< Now checking plug-in board.
<< MIDI bulk receiving...
<< MIDI bulk transmitting...
<< C 3:128[ ]
<< Completed.
<< Are you sure ? [YES]/[NO]
<< Overwrite? [YES]/[NO]
Meaning
Failed to process the MIDI data because too much data was received at once.
>>
>> Error occurred when receiving MIDI data.
>> Error occurred when receiving bulk data.
Internal backup battery needs to be replaced.
>>
>> No more available memory on the Memory Card.
>> Can t find the specified type of file.
>> Memory Card is faulty.
>> Memory Card has not been inserted, or an incompatible card (5V type) has been inserted.
Memory Card has not been formatted.
>>
>> Memory Card is write protected.
>> Memory Card has been wrongly formatted.
File with the same name already exists.
>>
>> Data in the file is corrupted and cannot be used.
>> The specified file name is not in MS-DOS format.
>> File is a read-only type, and cannot be deleted, renamed or saved.
>> A file could not be created on the Memory Card.
No further directories can be created.
>>
>> Directory cannot be entered because it is too deep.
>> File format is not recognized.
Bulk data cannot be received because protection is enabled.
>>
>> Bulk data cannot be transmitted/received because the device number is set to "off."
>> Bulk data cannot be transmitted/received because the device numbers don t match.
>> Cannot be used because Slot 1 contains a Multi-Part Plug-in Board.
>> Cannot be used because Slot 2 contains a Effect Plug-in Board.
Plug-in Board in Slot 1 is not working properly.
>>
>> Plug-in Board in Slot 2 is not working properly.
>> Sound requires a different Plug-in Board to that inserted in Slot 1.
Sound requires a different Plug-in Board to that inserted in Slot 2.
>>
>> When used with a PLG100 series Plug-in Board, a data file of which File Type
is plugin cannot be stored on a Memory Card.
>> Operation is being executed.
>> Memory Card operation is being executed.
File is being loaded from Memory Card.
>>
>> File is being saved to Memory Card.
>> Plug-in Board(s) is/are being checked (after powering up the synthesizer).
MIDI Bulk data is being received.
>>
>> MIDI Bulk data is being transmitted.
Stored. >> Sound has been stored.
Operation has completed.
>>
>> Final confirmation.
>> There is a file already stored with the same name. Replace it with a newer
one with that name?
151