IBM 1410 Manual page 63

Data processing system
Hide thumbs Also See for 1410:
Table of Contents

Advertisement

HUNNING PROCEDURE
A.
Make a TCoO diagnostic tape ready on tape drive 0 of any
channel.
1. Display memory location 00000
2. Alter lo:
vv
v
RL%B000011$.
For E channel tape
vv
v
XLoBll00011$.
For F channel tape
3.
Deprcos Tape Load Button
B.
Set to RU!\, COMPUTER RESET, START
The above procedures will load a very short load routine.
This load rnutine will load CCOl. Upon successful comple-
tion, CCO
I
will load and initiate the search section of TC50.
Appendix
t
of TC50 contains a description and listing of the
short load l'Outine that is the first record of the TC50 diag-
nostic tape.
C.
Upon initial loading, TC50 Search will type: "OPTION?" --
Upon Completion of that selection, "OPTION" will be typed
again.
At this
ti111c
use the inquiry button to enter one of the
following:
1. *Prog1·am identity, ie., "CUOl.
11
Designated program will
run in
its
entirety.
or 2.
*Left portion of a program identity.
All
pruµ;rams
adjacent 'on the tape, having the designated
portion of the identity will be run in their entirety, i.e.,
if ncT! were entered, all programs with a
11
C
11
identity
would
l>c
run;
if
11
cun
were entered, all programs with
a 1TC1J
11
identity would be run;
if
11
Cuon were entered, all
progr;1111s with a
11
CU0
11
identity would be run; etc.
or 3.
Nothin1~
(Just request
I
release)
All
pr(li~rams
on the tape will be run in sequence starting
at the pui.nt the tape is located when this entry is made.
or 4.
$
Enter
i
ug a dollar sign will select the reliability mode de-
scribed in Section 1. 01. 00. SO of the TC50 write-up.
*Note:
Normally, when a program identity or a portion of a
program identity is entered, the diagnostic tape is rewound be-
fore the search of the tape is started. If a word mark is entered
along with the first character of the identity, the rewind will be
inhibited.
IDperatinµ; Hin t.s and Comments
The operation
t)f
the search section of TC50 requires very little
knowledg;c of Lhe program. Knowing the various available options
should be suf!icient. A selected program must be re-selected to
be rerun.
63

Advertisement

Table of Contents
loading

Table of Contents