Related Manuals for Gree GWC09ATBXB-K6DNA1C/I
Summary of Contents for Gree GWC09ATBXB-K6DNA1C/I
- Page 1 Owner's Manual Original Instructions CONTENTS NOTE: Actual product may be different from graphics, please refer to actual products.
- Page 2 GWC12ATCXB-K6DNA1B/I GWC24ATEXF-K6DNA1E/I GWC28ATEXF-K6DNA1A/I GWH09ATBXB-K6DNA1C/I GWH12ATCXB-K6DNA1B/I GWH24ATEXF-K6DNA1E/I GWH28ATEXF-K6DNA1A/I...
- Page 3 Explanation of Symbols WARNING CAUTION Exception Clauses...
- Page 4 The refrigerant This appliance is not intended for use by persons Before install the Appliance filled (including children) with reduced physical, sensory appliance, read with flammable or mental capabilities, or lack of experience an d the installation gas R32. knowledge, unless they have been given superv- manual first.
- Page 5 Installation notes Welding table a - Minimum room area ( m ) Filling the refrigerant Safety instructions for transportation and storage Maintenance notes...
-
Page 6: Safety Precautions
Safety precautions WARNING Installation... - Page 7 Safety precautions CAUTION Installation Instructions for installation For the air conditioner with- and use of this product are out plug, a circuit breaker provided by the manufac- must be installed in the turer. line. Select a location which is The yellow-green wire in out of reach for children air conditioner is ground- and far away from animals...
- Page 8 Safety precautions WARNING Operation and Maintenance...
- Page 9 Safety precautions CAUTION Operation and Maintenance...
-
Page 10: Installation Notice
Installation notice WARNING sure that the unit is running in cooling mode. Then, fully close the valve at high pressure side (liquid valve). About 30-40 seconds later, fully close the valve at low pressure side (gas valve), immediately stop the unit and disconnect power. - Page 11 Basic requirement Grounding requirement Indoor unit Safety precaution...
-
Page 12: Installation Of Indoor Unit
Installation of indoor unit Step 1: Choose installation location Step 2: Step 4: Install wall-mounting frame Outlet pipe Step 5: Connect the pipe of indoor unit Step 3: Open piping hole... - Page 13 NOTE Step 7: Connect wire of indoor unit NOTICE Step 6: Install drain hose...
- Page 14 drain hose connection pipe Remove the wire clip; connect the power conn- band ection wire to the wiring terminal according to the color; tighten the screw and then fix the po- wer connection wire with wire clip. indoor power cord Bind them evenly.
-
Page 15: Clean And Maintenance
Clean and maintenance WARNING The filter should be cleaned every three months . WARNING If there is much dust in the operation environme- nt, clean frequency can be increased. Turn off the air conditioner and disconnect the After removing the filter, do not touch fins to power before cleaning the air conditioner to av- avoid injury.