Table of Contents
Advertisement
Available languages
Available languages
System outer foil
(see tig. 4)
The system outer foil has a slit blade
(a) between two foils (b). They move
up and down independently to follow
the contours of your face.
The slit blade catches and cuts
longer and lying hairs easily.
Cleaning your shaver
(see fig. 5)
For cleanliness and convenience, we
recommend
that you clean your
shaver with water and a liquid hand
soap. Regular cleaning will keep your
shaver in good condition while pre-
venting odors or bacteria from devel-
oping, and maintain the cutting per-
formance.
With the system outer foil in place,
apply some hand soap onto the outer
foil.
Turn the shaver on and pour some
water over the outer foil.
After about 10-20 seconds, turn the
shaver off.
Remove the foil frame and clean it
with running water.
Wipe off any moisture from the
shaver with a dry cloth and remove
the protective cap to allow the sys-
tem outer foil to dry completely.
Brush cleaning
Squeeze the system outer foil re-
lease buttons and lift the system
outer foil upward to remove it (see
fig. 6). Remove the inner blade by
grasping it firmly at both ends and
pulling it straight away from the
shaver (see fig. 7}. Clean the outer
foil, the shaver body the tong side of
the brush.
Clean the inner blade with the short
side of the brush. Do not use the
short brush to clean the outer foil
(see fig. 8).
Replacing shaving head
components
It is recommended that you replace
the outer foil at least every year and
the inner blade at least every two
years to maintain your shaver's cut-
ting performance.
Replacing the system outer foil
(see fig. 6)
Squeeze the outer foil release but-
tons and lift the outer foil upward to
remove it. To insert the new outer foil,
press down until it snaps into place.
Replacing the inner blades
(see fig. 7)
Squeeze the system outer foil re-
tease buttons and lift the system
outer foil upward to remove It. Re-
move the inner blade by grasping it
firmly at both ends and pulling
straight away from the shaver. To in-
sert the new inner blade, hold the
blade at both ends and press down-
ward until it snaps into place.
Caution
s The outer foil is very thin. If han-
died improperly, it can be easily
damaged. To avoid personal injury,
do not use the shaver if it has a
damaged foil or inner blade.
* Do not take the housing apart as
this can affect the watertight con-
struction.
¢ lí the shaver is not used for a long
time, remove the batteries to pre-
vent possible leakage.
« Do not use other
batteries than
Panasonic.
* Do not use new battery with old one
as the battery's life is reduced.
Advertisement
Table of Contents
