Driving Tips; Changing A Wheel; Tools; Spare Wheel - Jeep AVENGER 2023 Quick Manual

WARNING
17) Do not charge if the external
temperature is -30°C or lower, as charging
is likely to take longer and the charging
device may be damaged.
18) In cold temperatures, the charging
cable may become stiff. Therefore, be
careful not to apply excessive force to the
charging cable as it may be damaged.
19) Do not use personal generators to
charge the high-voltage battery. This may
cause fluctuations in charging and the
voltage may be insufficient, resulting in
damage to the car system.
20) Charging the high-voltage battery using
incorrect or damaged sockets, or charging
cables and not following the prescribed
charging procedures may cause short
circuits, fire and potential risk of damage to
the electrical system of the car.
21) Avoid leaving the high-voltage battery
for several days with the charge indicator at
or near zero. The high-voltage battery may
be damaged.
22) You do not need to wait until the high-
voltage battery level is low to recharge. The
performance of the high-voltage battery is
optimal when it is charged regularly.
23) Charging the high-voltage battery may
take longer if the temperature of the high-
voltage battery is high or low.
24
24) During charging, especially with fast
charging, high-voltage battery cooling
components may be voltage activated.
Therefore, it is normal to hear noises during
this operation.

DRIVING TIPS

In daily use, the consumption of an electric
car may depend on the following factors,
which can have a considerable impact:
 Car maintenance
 Tyre pressures
 Unnecessary loads
 Roof rack/ski rack
 Electric devices
 Climate control system use
 Devices for aerodynamic control

CHANGING A WHEEL

(where the spare wheel is provided)
89) 90) 91) 92) 93) 94) 95) 96) 97)

TOOLS

(where provided)
The tools fig. 29 are located in the toolbox
under the carpet or in a dedicated bag.
29
1. Jack - 2. Wheel wrench - 3. Towing
eye - 4. (not available) - 5. Chock (where
provided) - 6. Adapter for the locking wheel
nuts (where provided) - 7. Screwdriver -
8. Torx T30 screwdriver (where provided) -
9. Hex wrench (where provided)

SPARE WHEEL

(for versions/markets where provided)
The temporary spare wheel is located in
the load compartment beneath the floor
covering. The temporary spare wheel is
secured with a wing nut. Unscrew nut and
take out the spare wheel.
Only mount one temporary spare wheel.
JJ000725