Table of Contents
Advertisement
4.5 Connecting the appliance
Connecting water inlet hoses
Connect the water inlet hose for
1.
hot water
(red) and cold wa-
ter
(blue) to the appliance.
Connect the water inlet hose for
2.
hot water
(red) and cold wa-
ter
(blue) to the tap (26.4 mm =
3/4").
If there is no water tap for hot wa-
ter, only connect the water inlet
hose for cold water. Cover the hot
water connection on the appliance
in order to protect it from dirt.
Tip: To protect against dirt, use a
3/4" end cap on the hot water con-
nection of the appliance.
Open the water taps carefully and
3.
check that the connection points
are tight.
Installation and connection en
Water outlet connection types
This information is intended to help
you to connect this appliance to the
water outlet.
ATTENTION!
When draining, the water outlet hose
is subject to water pressure and may
come loose from the installed con-
nection point.
Secure the water outlet hose
▶
against unintentional loosening.
Note: Observe the draining heights.
The maximum draining height is
100 cm.
Siphon
Sink
Plastic pipe with
rubber sleeve or
gully
Connecting the appliance to the
electricity supply
Note: Your electrical domestic install-
ation for this appliance must comply
with the local legal provisions and
Secure the con-
nection point with
a (24–40 mm)
hose clamp.
Fix and secure
the water outlet
hose with an el-
bow.
→ "Accessories",
Page 28
Fix and secure
the water outlet
hose with an el-
bow.
→ "Accessories",
Page 28
15
Advertisement
Table of Contents
