Yamaha MD4S Owner's Manual page 20

20
Welcome to the MD4S
E
Time counter mode
This indicates the time counter mode that was selected by the DISPLAY button (disc transport
M
). However if a tempo map has been programmed and the time counter is showing
measure/beat/clock, all of these indicators will be dark.
ELAPSE TIME
TOTAL TIME
REMAIN TIME
F
MIDI indicators
The status of various MIDI functions is shown here.
MTC SYNC MASTER
MTC SYNC SLAVE
MIDI CLK
MMC
G
Track level meters
These indicate the recording/playback level of each track. The range from –39 dB to CLIP is
shown in nine steps. The CLIP indicator will light to indicate that digital clipping has
occurred in the signal. If no disc is inserted, these meters will indicate the input levels of input
channels 1–4.
H
Stereo level meter
This meter indicates the output level of the STEREO OUT jacks. The range from –20 dB to
+12 dB is shown in nine steps.
I
CUE MIX indicator
This indicates the on/off status of the cue mix function. If you record while the cue mix
function is on, this indicator will blink, indicating that the cue mix function has been
temporarily turned off.
J
Track recording indicators
These indicate the recording status of each track. When a indicator is blinking, the
corresponding track is ready to record. When recording begins, the blinking indicator will
light solidly.
DIR/1–4
BUS/L, R
—Owner's Manual
...... The time counter will show the current elapsed time within the song.
......... The time counter will show the time position within the entire disc.
...... The time counter will show the remaining time within the son
.......... This will light when you enable MTC transmission. In this case,
the MD4S will transmit MTC and will function as the master of
a synchronized MIDI system.
.............. This will light when you enable MTC reception. In this case, the
MD4S will receive MTC and will function as a slave in a
synchronized MIDI system.
.............. This will light when you enable MIDI Clock transmission. In this case, the
MD4S will transmit MIDI Clock and will function as the master of a
synchronized MIDI system.
...................... This will light when you enable MMC (MIDI Machine Control) reception.
In this case, the MD4S can be controlled from an external device such as a
MIDI sequencer.
................. These indicate tracks that have been selected for direct recording (in which
the signal from the input channel is recorded directly).
............... These indicate tracks that have been selected for recording the signal from
the ST bus (L or R channel).