Table of Contents
Advertisement
Troubleshooting
In the recording
and playback
modes
Symptom
Cause and/or Corrective Actions
The power does not turn on.
• The battery
pack is not installed,
or is dead or nearly
dead.
4. Install a charged
battery
pack. (p. 10, 11)
• The AC power
adaptor
is not connected
to a wall outlet.
4, Connect
the AC power
adaptor
to a wall outlet. (p. 14)
The end search function does not
* The tape was ejected after recording.
work.
• You have not recorded
on the new cassette
yet.
The end search function does not
• The tape has a blank portion
in the beginning
or middle.
work correctly.
The battery pack is quickly
• The operating
temperature
is too low.
discharged.
• The battery
pack is not fully charged.
4. Charge
the battery
pack fully again. (p. 11)
• The battery
pack is completely
dead, and cannot be
recharged.
4. Replace
with a new battery
pack. (p. 10)
• You have used the battery
pack in an extremely
hot or
cold environment
for a long time.
• The battery
pack is completely
dead, and cannot
be
recharged.
4. Replace with a new battery
pack. (p. 10)
• The battery
is dead.
4, Use a charged
battery
pack. (p. 10, 11)
• Charge
the battery
pack fully again so that the indication
on the battery
remaining
indicator
is correct.
The battery
remaining
indicator
does not indicate
the correct
time.
The power goes off although
the
battery remaining
indicator indicates
that the battery pack has enough
power to operate.
The cassette cannot be removed
from
• The power
source is disconnected.
the holder.
4. Connect
it firmly. (p. 11, 14)
• The battery
is dead.
4, Use a charged
battery
pack. (p. 10, 11)
The [] and A indicators
flash and no
• Moisture
condensation
has occurred.
functions except for cassette ejection
4, Remove
the cassette
and leave your camcorder
for at
work.
least 1 hour to acclimatize.
(p. 117)
110
Advertisement
Table of Contents
