Operation - Husqvarna RIGG 900 FE Operator's Manual

5. Lower the top frame onto the roof frame. Use
applicable lifting equipment.
6. Install the top frame (D) and the 2 brackets (E)
on the roof frame. Use 8 M16x130 bolts, 16 M16
washers, and 8 M16 locknuts.
Introduction
WARNING:
safety chapter before you use the product.
WARNING:
clamps on the steel wire ropes are
tightened.
To do before you operate the product
1. Read the operator's manual for this product, the
EBE 900 V shot blaster, and the dust collector
carefully and make sure that you understand the
instructions.
2. If a generator is used as a power source for the
product, read and understand the operator's manual
of the generator.
2150 - 002 - 08.02.2024
D
F
E

Operation

Read and understand the
Make sure that the 6
7. Install the 2 brackets (F) with 4 M12 locknuts and 4
M14 washers.
8. Adjust the drive wheels to the diameter of the
storage tank. Refer to
the diameter of the storage tank on page 9 .
3. Use personal protective equipment. Refer to
Personal protective equipment on page 6 .
4. Do a visual inspection of the product. Refer to
a visual inspection on page 12 .
5. Make sure that the product is assembled correctly
and is not damaged.
6. Make sure that all bolts, screws and nuts are
tightened.
7. Do daily maintenance. Refer to
schedule on page 14 .
8. Install the product on the storage tank. Refer to
install the product on a storage tank on page 10 .
9. Make sure that only approved persons are in the
work area.
10. Make sure that the ON/OFF switch is in the OFF
position before you connect the product to a power
supply.
11. Connect the product to a power source. Refer to
connect the product to a power source on page 12 .
To adjust the drive wheels to
Maintenance
To do
To
To
11