Configuration Of Konftel 800; Setting The Password For Konftel 800 - Konftel 800 Installation & Administration

INITIAL SETUP AND CONFIGURATION
If this file has a higher value, the phone ignores it as it may contain unknown
or changed parameter formats.
For example, <KT800 version="7"> on the top of the 1.0.7 firmware
compliant .xml file for the device with 1.0.6 firmware installed indicates that the
file received has a higher value than the file available on the device. Konftel
800 rejects such a file.
The phone stores the configuration in its non-volatile memory.
• Generic firmware version file kt800_fw_version.xml. The device also
compares this file with the current running firmware. If there is a difference,
Konftel 800 requests the firmware identified in the kt800_fw_version.xml
file from the HTTP server.
After upgrade or downgrade, the phone reboots and repeats all the described
actions. If there are no changes in the content of the various .xml files, the device
ignores them and applies the configuration stored in its non-volatile memory.
If the device does not obtain an IP address and the configuration file does
not specify an administrator password, Konftel 800 prompts you to set the
administrator password. You need this password to access the phone admin
menu and the web-based admin menu using an Internet browser.
Related concepts
Firmware upgrade and downgrade
Related information
Configuration parameters

CONFIGURATION OF KONFTEL 800

Konftel 800 can use the following methods to obtain the required configuration
parameters:
• Centralized HTTP/HTTPS server.
• Konftel 800 web interface when you log in as the administrator.
• Konftel 800 phone interface.

Setting the password for Konftel 800

About this task
Use this procedure to set your Konftel 800 password when you first activate
the phone or after a reset to the factory settings. By default, the administrator
password is not set.
on page 129
on page 35
21