Advertisement
Quick Links
Advertisement
Related Manuals for Haier HDHPS70LW1
Summary of Contents for Haier HDHPS70LW1
- Page 1 HDHPS70LW1...
- Page 2 Warning: Risk of fire/Flammable materials Read the instructions...
- Page 3 Safety information..........................4 Product description........................9 Control panel..........................10 Dry cycles............................13 Dry Preparation..........................14 Getting started quickly........................16 Care and clean..........................18 Before you call for sevice......................21 Fault codes.............................22 Troubleshooting..........................23 Installation............................26 Customer Care..........................31...
- Page 4 Before First Use - Do not operate this machine if it has been damaged during transport. Contact your dealer or Haier service technician. - Ensure all transport bolts are removed before running the appliance. Failure to do so might end in damage to the apppliance.
-
Page 5: Intended Use
- Do not operate this product without the lint filter in place or allow lint to accumulate in or around the appliance. - If the lint filter is damaged, contact your Haier service technician to arrange getting a new filter. Do not operate your appliance with a damaged lint filter or without the filter in place, as this will cause... - Page 6 Dryer Information - If ducting the dryer to the outdoors, ensure adequate ventilation is provided during operation of the appliance to avoid any backflow of gases from fuel burning appliances. - WARNING:The last stage of the drying cycle is a cool down phase. Never stop a tumble clothes appliance before the end of the cycle unless all items are removed and spread out in order to dissipate the heat.
-
Page 7: Maintenance, Cleaning And Disposal
- Do not use water spray or steam to clean the appliance. - A damaged electrical cable must be replaced by a Haier service technician or similarly qualified person. Do not use the appliance until it has been repaired to avoid a risk of electric shock. - Page 8 Ensure you use the compatible stacking kit for your washer and dryer combination. Stacking kits are available through your Haier Brand dealer or online Ensure that the power plug is always accessible.
- Page 9 2.1 Picture of appliance Rear side (Fig.2-2): Front (Fig.2-1): 2.2 Acceffories Check the accessories and literature in accordance with this list (Fig.2-3)：...
- Page 10 Dela Left Right Favorite indicator Delay 3.1 Clean filter indicator Filters must be cleaned regularly. See Lint Filter Cleaning or Condenser Filter Cleaning section of the manual. Favourite mode Choose a program and the desirable modifiers, then start the cycle. Press “Dry-Level + Anti-crease” for 3 seconds to save the personalised options.
- Page 11 Press the Dry-Level button (Fig. 3-4) to change the end dry level of the program. H1: Damp/Dry - This setting is recommended for ron treatment. H2: Dry - This setting is recommened for the majority of garments; garments can be worn after drying. H3: Extra Dry - Use this setting for large, bulky and durable items.
- Page 12 Right Select Programs to the right 3.10 3-10 Press the Start/Pause (Fig. 3-10) to start or pause the selected program. 3.11 Power 3-11 Press the Power button (Fig. 3-11) to turn ON and OFF the product. Mute 3-12 Press and hold Time and Delay combination keys for three seconds to turn OFF or turn On the buzzer, and the display will show "bEEP OFF"...
- Page 13 Autosensing cycle for garments Cotton made of cotton fabrics. Autosensing cycle for garments Synthetics made with synthetic fabrics or synthetic blends. Gentle autosensing cycle for Delicate delicate garments. Autosensing cycle designed to dry thick, durable and absorbent items Towels such as towels. Autosensing cycle for loads with Mixed different types of clothes and...
- Page 14 Sort items into loads of similar items,and loads that will likely take similar times to dry.This prevents the possibility of some items becoming over-dried whilst others are still damp. Separate coloured items from white/light items where possible, especially when new. Colour run may be an issue, especially if you intend to delay the start of the drying cycle.
- Page 15 Delicate or easily damaged items (eg nylon stockings fabrics, delicate embroidered fabrics) should be dried separately, using the DELICATE cycle.
- Page 16 Press the Power button to start the machine Select the required program by pressing the Left and Right buttons, and the LED in front of the corresponding program name will light up Delay...
- Page 17 power off...
- Page 18 Clean the lint filter from any lint residuals(Fig.7-2). 2. Pull out the lint filter from its housing(Fig.7-6). 3. Pull out the condenser filter from the air duct(Fig.7-7). 4. Remove the sponge and clean the filter screen from any residuals(Fig.7-7)
- Page 19 There are sensors in your dryer that detect whether the laundry is dry or not. These sensors need to be cleaned periodically (we recommend approximately four times a year). 1.Open the door of your dryer. Allow the dryer to cool if drying has been carried out.
- Page 21 ‘Troubleshooting', 'Dryer is taking too long.’for possible causses and solutions. Once you have addressed the issue the user prompt was alerting you to, try using your dryer as per usual. If the issue persists, call your Haier trained and supported service technician.
- Page 22 When a continuous series of beeps sound, all the lights turn off on the conitrol panel and a string of codes appears on the display ’a fault has occurred’ . Please call your trained and upported Haier service technician.
- Page 23 Check whether the drain hose is blocked. Check the drain hose is still attached Drain hose is blocked Small amount at the back of the machine, and is not of water in kinked or squashed. the drum at end of cycle If conditions are particularly hot, Environmental conditions humid or cold, it is possible vaporised...
- Page 24 Ensure the lint filter is cleaned after Lint filter not cleaned or every cycle and replaced correctly. replaced. Refer to 'Cleaning the filters'. Dry lint-giving items separately from lint receivers. Also, dry similar colours together, eg light coloured items with Loads not sorted correctly.
- Page 25 Try separating out larger items from Loads not separated during smaller items. loading. Tangling Load items individually into the dryer. Items loaded into the dryer Do not place folded items in the dryer. incorrectly. Try drying smaller load sizes. Load size too large. Some cycles have a lower maximum load size.
-
Page 26: Product Dimensions
Product dimensions ○ PRODUCT DIMENSIONS Overall height* ○ - Min : 845mm ○ - Max :850mm Overall width : 595mm ○ ○ Overall depth :595mm ○ ○ Depth of open door : 1040mm ○ *Exact height is dependent on foot adjustrment **Including dial and door (when closed) PLAN... -
Page 27: Clearance Dimensions
○ ○ ○ ○ ○ CLEARANCE DIMENSIONS ○ Minimum washer door clearance to adjacent wall :298mm Minimum gap clearance to adjacent product or cabinetry : 20mm ○ *Applies to sides, top and rear... - Page 28 Stacking Installation Dryer Stacking Kit Washing Machine -The following washing machine models can be stacked with this machine using a Stacking Kit. HWF75AW3,HWF85AN1,HWF95AN1,HWF90AN1,HWF10AN1; For the stacking installation method, refer to the instructions of the Stacking Kit .
- Page 30 You can setup...
-
Page 31: Customer Care
If you cannot find a solution there please contact: - Your local dealer, or - The Service and Support area at www.haier.com where you can find telephone numbers, FAQs and where you can activate a service claim Before contacting our service team, ensure that you have the following information available. - Page 32 0180501822...