Monitoring - Yamaha 03D Owner's Manual

74
Chapter 7—Solo, Monitors & Meters

Monitoring

On the Moni.Setup page you can select the stereo output, aux sends, bus outs, or stereo
cascade input as the monitor source. These signals are monitored via the monitor out
and phones. Functions on this page do not affect the [SOLO] button or stereo output.
1. Use the [SOLO SETUP] button to locate the Moni.Setup page shown
below.
2. Use the cursor buttons to select the parameters, and the [ENTER] button
and PARAMETER wheel to set them.
If you are using a mouse, simply click the switches and drag the rotary control.
MONITOR SOURCE SELECT —These switches are used to select the signal source for
the monitor out and phones. You can select the stereo out, aux sends, bus outs, and the
stereo cascade input. When aux sends or bus outs are configured as stereo pairs, these
switches are linked.
LISTEN —These switches set the monitor signal source to pre-fader (PFL) or post-fader
(AFL). This is a global setting that affects all monitor sources (i.e., stereo out, aux sends,
etc).
SEL MODE —These switches set the monitor select mode. In LAST MONI mode, only
one monitor source can be selected at a time. In MIX MONI mode, however, several
monitor sources can be selected. Selected signals are mixed.
MONI TRIM —This control is used to adjust the level of the monitor signal from
–60 dB to +6 dB. This control can be adjusted using the PARAMETER wheel regardless
of cursor position.
STEREO/MONO —This switch sets the monitor and phone's signals to mono or ste-
reo. It functions independently of the MONO switch on the Solo Setup page. When on,
the left and right signals are summed together to form a mono mix. The level of the
summed mix is attenuated –3 dB.
03D—Owner's Manual