Feed Base Block Assembly; Mounting The Feed Base Block Assembly - Sony MDP-V10 Service Manual

2-9. FEED BASE BLOCK ASSEMBLY

2 Two screws
(BVTP3 x 10)
7 Connector (CN203)

2-10. MOUNTING THE FEED BASE BLOCK ASSEMBLY

Note: Follow the assembly procedure in the numerical order given.
2 Fix the feed base block assembly temporarily with three screws.
(BVTP3 x 10)
9 Adjust feed base block assembly so that the Lissajous's waveform
goes to 0˚. (Tighten the screw completely.)
!¡ Refer to 7-5. Adjustment after the attachment of the optical pick-up block.
Tilt disc
(Put aside in the
direction of arrrow.)
0 Two screws (BVTP3 x 8)
7 Set the CD (YEDS-18) on the tray.
Press the PLAY ( · ) button and plays the track No. 1 PAUSE.
1 Two screws
(SUMITITE (B3), +BV)
Fig-B
4 Connector
(CN203)
3 Screw
5 Flat cable (CN701)
8 Turn off TRACKING
and SLED switches.
MD adjustment cable
1 Tilt link shaft assembly
Note on installation:
Setting the tilt slider and tilt disc
at the position shown as Fig-A, B.
2-5
(BVTP3 x 10)
4 Flat cable (CN301)
6 Flat cable (CN503)
6 Connect to the oscilloscope.
Oscilloscope
Lissajous's waveform
180˚
CH-1
E
CH-2
F
5 Connect the connec-
tor of MD adjustment
cable with the pattern
face down. (CN702)
3 Three flat cable
(CN301, CN503, CN701)
Tilt slider
(Put aside in the
direction of arrrow.)
Fig-A
90˚ 0˚