Traxxas Ford Fiesta ST Rally VXL Owner's Manual page 27

Suspension and slipper clutch assembly removal
Your model was designed with ease of disassembly in mind. The entire
front and rear suspension assemblies can be removed from the chassis
fully intact with the removal of only a few screws. Refer to the exploded
views included in the Service Support Guide for complete assembly
diagrams.
Removing the front suspension module
1. Remove the two 4x12 button-head cap screws from the front of the
chassis.
2. Remove the two 4x10 button-head cap screws from the top of the
chassis.
3. Remove the 3x15 button-head cap screw from the steering link under the
chassis.
4. Pull the front suspension assembly away from the chassis.
5. The driveshaft will come out with the front module. Remove screw
pin to remove driveshaft.
Removing the rear suspension module (slipper clutch assembly
removal)
1. Remove the two 4x12 button-head cap screws from the top of the
chassis.
2. Remove the two 4x14 button-head cap screws from the bottom of the
chassis.
3. Pull the rear suspension assembly away from the chassis.
4. The high-stall gear clutch assembly can now be removed.
4x10BCS
4x12BCS
3x15BCS
Front Suspension
Assembly
www.modellmarkt24.ch
MAINTAINING YOUR MODEL
Rear Suspension
High-Stall Gear
Clutch Assembly
4x12BCS
4x14BCS
Assembly
FIESTA ST RALLY VXL • 27