Table of Contents
Advertisement
The Traxxas iD® High-Current Connector
Your model is equipped with the Traxxas iD®
High-Current Connector. Standard connectors
restrict current flow and are not capable of
delivering the power needed to maximize the
output of the electronic speed control. The Traxxas connector's gold-
plated terminals with large contact surfaces ensure positive current
flow with the least amount of resistance. Secure, long-lasting, and easy
to grip, the Traxxas connector is engineered to extract all the power
your battery has to give.
TRAXXAS TQ
i
SETTING UP THE ANTENNA
The receiver antenna has been set up
and installed from the factory. The
antenna is secured by a 3x4mm set
screw. To remove the antenna tube,
simply remove the set screw with the
included 1.5mm wrench.
When reinstalling the antenna, first
slide the antenna wire into the bottom
of the antenna tube until the white
tip of the antenna is at the top of the
tube under the black cap. Next, insert
the antenna tube into the mount while
making sure that the antenna wire
is in the slot in the antenna mount;
then, install the set screw next to the
antenna tube. Use the supplied 1.5mm
wrench to tighten the screw just until
the antenna tube is securely in place.
Do not over tighten. Do not bend or kink the antenna wire! See the side
bar for more information. Do not shorten the antenna tube.
www.modellmarkt24.ch
RADIO & VELINEON POWER SYSTEM
Antenna
Tip
Antenna
Tube
Antenna
Mount
Make certain the model's
receiver antenna is properly
installed before operating
your model. Failure to
properly install the receiver
antenna will result in greatly
reduced radio range and
potential loss of control.
To prevent loss of radio range,
do not kink or cut the black wire,
do not bend or cut the metal tip,
and do not bend or cut the white
wire at the end of the metal tip.
No
No
No
Correct
5 5
FIESTA ST RALLY VXL • 15
Advertisement
Table of Contents
