Traxxas Ford Fiesta ST Rally VXL Owner's Manual page 23

RECEIVER BOX:
MAINTAINING A WATERTIGHT SEAL
Removing and Installing Radio Gear
The unique design of the receiver box allows the removal and
installation of the receiver without losing the ability to maintain a
watertight seal in the box. The patent-pending wire clamp feature
gives you the ability to also install aftermarket radio systems and
maintain the watertight features of the receiver box.
Removing the Receiver
1. To remove the wire clamp, remove the two 2.5x12mm socket-head
cap screws.
2. To remove the cover, remove the two 3x12mm button-head cap
screws.
3. To remove the receiver from the box, unplug the servo cables from
the receiver and remove the receiver.
Receiver Installation
1. Using double-sided adhesive foam tape,
install the receiver into the box. Make
sure the box light pipe is aligned with the
receiver LED.
Note: For best performance, it is recommended
that the receiver be installed in the original
orientation as shown.
2. Install the servo wires and antenna through the
cover and plug the wires into the receiver.
3. Make sure the O-ring is properly seated
into the groove in the receiver box so that
the cover will not pinch it or damage it any
way.
4. Install the cover and tighten the two 3x12mm
button-head cap screws securely.
5. Inspect the cover to make sure that the O-ring seal
is not visible.
6. Arrange the wires neatly using the wire guides in
the receiver box.
7. Apply a small bead of silicone grease (part #1647) to the wire clamp.
8. Install the wire clamp and tighten the two 2.8x12mm cap screws
securely.
www.modellmarkt24.ch
DRIVING YOUR MODEL
FIESTA ST RALLY VXL • 23