To Play A Desired Track On The Disc - Yamaha CDC-645 Owner's Manual

To stop play temporarily
* To resume play, press the PAUSE button again or the
PLAY button.
DIRECT PLAY
Select a desired track by using the numeric buttons on the
remote control transmitter.
Example: To select track 25
Press twice, then immediately press
10
* If a track number higher than the highest track number on
the disc is selected, the last track on the disc will be played.
Display information at disc play
PAUSE

To play a desired track on the disc

5
The selected track
number is displayed.
once.
5
To stop play completely
SKIP PLAY
To play from the beginning of the track following the one
now playing
To play from the beginning of the track now playing
To play from the beginning of the track before the one now
playing
(twice)
* These operations can also be performed when the unit is in
the pause or stop mode.
Encloses the tray number of the selected disc.
Shows the tray numbers with discs.
Shows the selected track number.
Shows the time displays. (Refer to "Selecting time
displays" on page 9.)
Displays the numbers that correspond to the numbers of
the tracks (as high as number 15) on the disc. After each
track is played, its corresponding number disappears so
the number of remaining tracks (and their numbers) can be
seen at a glance.
Shows the level of signals output into an amplifier or the
headphone level adjusted by using the OUTPUT LEVEL
control.
STOP
SKIP
SKIP
SKIP
7