To Play A Desired Track On The Disc - Yamaha CDC-745 Owner's Manual

To stop play temporarily
PLAY/
PAUSE
* To resume play, press the PLAY/PAUSE button again
(or press the PLAY or PAUSE button on the remote control
transmitter).
DIRECT PLAY
Select a desired track by using the numeric buttons.
+
10 1 2
Example: To select track 25
Press twice, then immediately press
+
10 1 2
* If a track number higher than the highest track number on the
disc is selected, the last track on the disc will be played.
Display information at disc play
8

To play a desired track on the disc

3 4 5 6 7 8
The selected track
number is displayed.
once.
3 4 5 6 7 8 9
PAUSE
SKIP PLAY
To play from the beginning of the track following the one
now playing
9 0
To play from the beginning of the track now playing
To play from the beginning of the track before the one now
playing
0
* These operations can also be performed when the unit is in
the pause or stop mode.
Encloses the tray number of the selected disc.
Shows the tray numbers with discs.
Shows the selected track number.
Shows the time displays. (Refer to "Selecting time
displays" on page 9.)
Displays the numbers that correspond to the numbers of
the tracks (as high as number 15) on the disc. After each
track is played, its corresponding number disappears so the
number of remaining tracks (and their numbers) can be
seen at a glance.
Shows the level of signals output into an amplifier or the
headphone level adjusted by using the OUTPUT LEVEL
control.
To stop play completely
STOP
SKIP
SKIP
SKIP
(twice)