Appendix A: Upgrading to
StarTalk Flash
If you are upgrading from a StarTalk Mini to a StarTalk Flash
,
the codes
from the StarTalk Mini software may still be stored in the KSU. You
must
remove the old codes using the External Feature Inquiry utility before
installing a StarTalk Flash
module.
From a Norstar set:
1.
Press
!Fea ture
I
~ ~
IBJ [] [] []
~
[]
which is the same as
Press
!Fea ture
J
~
~
[ ]
[D [] [D [] []
The display
shows:
Note:
Recess denied
appears if you cannot use external feature
inquiry from your
telephone.
In use:
appears if someone else is using external feature
inquiry,
or an external feature is requesting an external feature access
code.
2.
Enter <the Installer password>
The default password is CONFIG (266344). For more information
about the Installer password
,
refer to the Norstar Installer Guide
that came with your KSU
.
The display shows
3.
Press
FIRST
The external feature access codes from the previous StarTalk soft-
ware are cleared.
4.
Press
~
to exit external feature
inquiry.
You are now ready to install the StarTalk Flash module. Refer to
Installing the module earlier in this
guide.
StarTalk Flash Installation Guide