Table of Contents
Advertisement
•
5
Mounting steps
You must open the door of the unit before yoµ can mount the module.
To mount the module:
1.
Position the StarTalk Flash module next to the KSU and hold it
against the plywood backboard
.
2.
Install a #10 X 2.5 cm (#10 X1 in) wood screw in the top screw
hole, but do not tighten it completely.
3.
Make sure the module is level. Install and tighten a wood screw in
the bottom screw hole.
4.
Tighten the top screw to secure the module.
You are now ready to connect the module to the KSU
.
Mounting
screw holes
Figure 2
-
Mounting screw holes and connectors
power supply
connector
teledapt line
jacks
25-pin
0
connector
L'l
e
StarTalk Flash Installation Guide
Advertisement
Table of Contents
