Table of Contents
Advertisement
Connections
■ Install the KRC-999H in a following manner and wiring them
1. Before installation and wiring, remove the ( —) terminal of the battery to prevent
short-circuiting.
2. Connect the ground to the metal chassis of the car.
3. Connect the input and output cords of the system.
4. Connect the back-up power supply lead (yellow).
5. Connect the accessory power lead (red).
6. Install the set and after confirming the installation and wirings are correct, connect
the ( —) terminal of the battery.
7. After all installation and wiring are completed, be sure to press the Reset button.
Notes:---
When the fuse is blown, replace with a new one having the designated current capaci¬
ty after confirming that no cable is short-circuited.
■ Preamp output voltage selector (Rear panel)
High 1 V
m
Normal 300 mV
(En)
13
Advertisement
Table of Contents
