Table of Contents
Advertisement
•
When charging the shaver for the first time or when it has not
been in use for more than 6 months, the charge status lamp (
may not glow. It will eventually glow if kept connected.
Shave
Using the shaver
1
1
Press the power
switch.
Start out shaving by applying gentle pressure to your face.
Stretch your skin with your free hand and move the shaver back
and forth in the direction of your beard. You may gently increase
the amount of pressure as your skin becomes accustomed to
this shaver. Applying excessive pressure does not provide a
closer shave.
Caution
•
If you press the power switch for more than 2 seconds, the
sonic vibration cleaning mode is activated.
You cannot shave in this mode.
•
Do not place your fingers on the power switch while using the
shaver. This may cause the shaver to turn off or enter the sonic
vibration cleaning mode.
2
2
Hold the shaver as
illustrated above and
shave.
Page 5
Reading lamps when using
)
•
The charge status lamp (
•
It will turn off approximately 5 seconds after operating the
switch.
When the battery capacity is low
The battery capacity lamp (
•
You can shave 2 to 3 times after the battery capacity lamp (
blinks (This will differ depending on usage.)
•
A full charge will supply enough power for approx. 1 shaves of
3 minutes each.
While using
) glows when using cord shaving.
) blinks when operating the shaver.
)
Advertisement
Table of Contents
