Panasonic SC-AK630 Operating Instructions Manual page 4

Connect the AC power supply cord only after all other connections have been made.
Optional antenna connections (,,_ page 10)=
Preparation
Twist and pull off the vinyl tip of the antenna wires and speaker cords. [
4 AC power supply cord
2 AM Joop antenna
Stand the antenna up
on its base.
The included AC power supply cord
is for use with this unit only.
Do not use it with other equipment.
For your reference
To save power when the unit is not
going to be used for a long time,
unplug it from the household AC outlet.
You will need to reset some memory
items after plugging in the unit.
FM indoor antenna
Affix where reception
is best.
F 3 Speakers
Placement
Place the front speakers so that the super tweeter is on the
inside=
Connection Red
Gray
(L)
Subwoofer
Front speaker _
(left)
Main unit
Subwoofer
Front speaker
(right)
o Keep your speakers at least 10 mm (W:_Z')away from the system
for proper ventilation.
o These speakers do not have magnetic shielding. Do not place
them near televisions, personal computers or other devices easily
influenced by magnetism=
o You cannot take the front net off the speakers.
Black
Black (-)
(SB-WAK630)
Black (-)
Btue (-) Gray (+)
Use on_y the supplied speakers.
The combination of the main unit and speakers provide the best sound.
Using other speakers can damage the unit and sound quality will be
negatively affected.
Notes on speaker use
o You cart damage your speakers and shorten their useful life if you
play sound at high levels over extended periods.
o Reduce the volume in the following cases to avoid damage.
- When playing distorted sound.
- When adjusting the sound quality.
Caution
o Use the speakers on_y with the recommended
system. Failure to do so may meadto damage to
the amplifier and/or the speakers, and may result
in the risk of fire. Consult a qualified service
person if damage has occurred or if you
experience a sudden change in performance.
e Do not attach these speakers to walls or
ceilings,
RQT7834
When the unit is first plugged in, a demonstration of its functions may
be shown on the display.
If the demo setting is off, you can show a demonstration by selecting
"DEMO ON"=
Press and hoBd [D_SP,-DEMO]o
The display changes each time the button is held down.
NO DEMO (off) _ DEMO ON (on)
While in the standby mode, select "NO DEMO" to reduce power
consumption.
DEMO function cannot be turned on when Dimmer is on.