Graco GM5000 Instructions-Parts List Manual page 17

REASSEMBLY
5. Place the engine (1) assembly on the cart, aligning
the mounting holes, and carefully guiding the engine
wire (D) and wiring harness (96) from the field,
through the appropriate grommets (66) in the mount-
ing plate (E). Secure the engine with the capscrews
(14), lockwashers (9) and nuts (61). Secure the
clutch housing (2) with the capscrews (15), lock-
washer (80) and washer (99). Under the mounting
connect the black and white wires. See Fig 33-1,
plate, connect the engine wire (A) to the red wireand
6. Making sure-the face of the rotor (4b) and the field is
free of all oil and contaminants, install the rotor,
lockwashers (11) and capscrews (16). Torque the
capscrews to 6.5 to 7.5 ft-lb
(8.8
to 10 N.m). See Fig
33-1.
7. Making sure the face of the armature (4a)
is clean,
assemble the armature to the shaft in the pinion
housing (19). A retaining ring located within the ar-
mature makes it difficult to assemble these parts.
gage a few splines of both parts. While they are en-
Follow this procedure for the best results. First, en-
gaged, use a screwdriverto gently push the retaining
ring into the armature and finish engaging the
splines. Push the armature onto the shaft until it con-
tacts the ring (19m). See Fig 33-1.
8.
Assemble the pinion housing (19) to the clutch
housing using capscrews (1
0)
and lockwashers (1 1).
See Fig 33-1.
Fig 33-1
VIEW UNDER ENGINE MOUNTING PLATE