Graco GM5000 Instructions-Parts List Manual page 15

ENGINE
NOTE: The engine must be removed before the Field,
Clamp or Clutch Housing can be removed.
1. Working under the mounting plate (A) of the cart, re-
move the screw (15), lockwasher
(80)
and washer
(99) holding the clutch housing (2) to the cart. See
Fig 29-1.
/
TOENGINE
66
TO FIELD
WHITE
2. Still working under the mounting plate, remove the
two nuts (61) and lockwashers (9), and then pull the
screws (14) out of the base of the engine. Discon-
nect the red wire from the engine lead (B). Discon-
nect the black and wire wires from the field. Pull the
wires carefully through the grommets (66) before re-
moving the engine. See Fig 29-1 and 29-2.
3. Lift the engine carefully and place it on awork bench.
4. Remove the Field and Wiring Harness, Clamp and
Clutch Housing. See pages
30
and
31.
lW/
5. Skip ahead to Reassembly, page 32, Step 1.
NOTE: All service to the engine must be performed by
VIEW FROM UNDER ENGINE MOUNTING
an authorized HONDA dealer. Fig 29-2
Fig
29-1
qn7
Q A ~