Know Your Snow Thrower - Cub Cadet 730 STE Operator's Manual

Cable
Discharge
Chute
Figure 3
• If not already attached, unwrap the headlight wire
which is attached to the headlight, beneath the
handle panel. Wind the headlight wire around the
lower right handle until excess slack is removed.
See Figure 4.
SECTION 2: KNOW YOUR SNOW THROWER
Drive Control /
Auger Control Lock
Headlight
Chute
Assembly
Clean-Out
Tool
Auger
WARNING:
all instructions and warnings on the machine
and in this manual before operating.
Cable
Guide
Chute Directional
Control
Skid Shoe
Read, understand, and follow
• Plug the wire from the headlight into the alternator
lead coming from the right side of the engine
underneath the fuel tank.
Lamp Wire
NOTE:
Wheels are omitted from illustration for clarity.
Clean-Out Tool
• This tool, along with the electric cord, is fastened
with a cable tie to the rear of the auger housing for
shipping purposes. Cut the cable tie and remove
the electric cord before operating the snow thrower.
Shift Lever
Chute Tilt
Control
Auger Drive Control
Track Steering
Control
Primer
Choke
Safety
Ignition Key
Throttle
Control
Figure 5
Drive Control / Auger Control Lock
The drive control is located on the right handle.
Squeeze the drive control to engage the wheel drive.
Release to stop. See Figure 5.
6
Alternator Lead
Alternator
Lead
Figure 4
Electric
Starter
Button
Switch
Box
Recoil
Starter
Handle