Technics SA-DA20 Operating Instructions Manual page 15

1
Adjusting speaker output level ]
Adjust the level of the speakers so theyare the same apparent level
as the front speakers when you are sitting where you would
normally enjoy a source.
1
Press [A] or [BI-WIRE] to turn on
SPEAKERS A or BI-WIRE.
You cannot adjust output level when SPEAKERS B Is on.
2
Press [TEST] to output the test signal.
DSP sound mode switches to SURROUND mode.
The signal is output from each speaker in order for about two
seconds each: - • .
L: Front speaker (left)
C; Center speaker
R; Front speaker (right)
RS; Surround speaker (right)
LS: Surround speaker (left)
SW: Subwoofer
Speakers set as "NONE" or "NO" are skipped.
The test signal will not be output if the VGCA (^ page 20) or •
DVD 6CH INPUT is on (^ page 19).
3
Adjust the volume to the level
normally used.
Adjust the balance of the front speakers if necessary
(^ page 21).
4
Press [LEVEL] to select the speaker
channel to adjust.
The current level appears on the display.
Press again to change the speaker channel.
Speakers set as "NONE" or "NO" are skipped.
5
Press [+] or [-] to adjust the level to
the same apparent level as the front
speakers. .
C, RS, and LS can be adjusted between -10 dB and +10 dB,
with zero being the current level of the front speakers.
SW can be set to MIN, between 1 to 19. or MAX.
Repeat steps 4 and 5 for each speaker channel.
6 Press [TEST] to stop the test signal.
For your reference
Subwoofer output is easily influenced by the source played. You
can achieve better results by adjusting its output while listening to a
source (^ page 21),
BOT5952