Panasonic PT-D7 Operating Instructions Manual page 31

Troubleshooting
This section helps you resolve problems you may encounter while setting up or using the unit.
Common Problems & Solutions
Does not turn on Check that the power cable is properly connected to the unit and wall outlet (the
` mains). (See page 15). l :
Check the STATUS indicator to see if the unit has overheated or the lamp usage
has exceeded 1100 hours. (See page 32.)
No picture ; Check that you have selected the proper input source jou wish to project. (See
pages 15 and 32.) `
Ensure all the cables are connected properly. ( See pages I] to 13.)
Adjust the brightness and contrast. (See page 28.)
Remove the lens cap. (See page 15.) |
Is the POWER indicator flashing? (See page 15.)
Is the STATUS indicator flashing? (See page 32.)
Image isn't square on the screen Reposition the unit to improve its angle on the screen. (See pages 15 and 16.)
Is the vertical offset properly corrected using the keystone function? (See page -
16). |
Picture is blurred — l Adjust the focus. (See page 16.)
Reposition the unit to improve its angle to the screen. (See pages 15 and 16.)
Ensure that the distance between the unit and screen is within the adjustment
range of the lens. (See pages 9 and 10.)
Remote control does not work Replace the dead batteries with new ones. (See page 5):
Make sure there is no obstacle between the remote control and the unit.
Stand within 4m (13 feet) of the unit. (See page 5.)
The STATUS indicator is lit or See ihe STATUS indicator message chart on the next page.
flashing
Cross color appears in RGB mode | + If "AUTO MODE" ts set to "ON," set it to "OFF" then manually adjust the
| clock frequency and clock phase. (See page 27.)
+ If "AUTO MODE" is set to "OFF," set it to "ON." (See page 27.)
31