Table of Contents
Advertisement
| DX-MX70BK
Using the Tape
Deck
The tape deck has an Auto Tape Select feature, which can tell the difference
between various types of cassette tape. It can distinguish between Normal
(Type I), CrO2 —
High Position (Type Il), and Metal (Type IV).
Playing a Tape
1. Press the EJECT button to open the cassette holder.
2. Insert a cassette and shut the cassette holder.
3. If the tape was recorded with Dolby noise reduction, use the DOLBY
NR switch.
Set the switch to the same mode as the tape was recorded in.
DOLEY
tT
IP 5
4. Start playback by either of the following methods:
® Press the
button.
Press the > button if the tape is
wound mostly on the left side.
Press the <J button if the tape is
wound mostly on the right side.
@
Press the TAPE button on the Amplifier.
Note: When cassettes are in both decks A and B, deck B starts first.
Stopping Playback and Ejecting the Tape
1. Press the STOP button on the tape deck.
ce
2. Press the EJECT button to open and remove the tape from the cas-
sette holder.
3. Shut the cassette holder.
Note: If the system is turned off while a tape is playing, you may not be
able to eject the tape. You will need to turn the system back on and press
the EJECT button to open the cassette hoider.
Stopping and Restarting Playback
1. Press the PAUSE button on the tape deck.
©
Playback of the tape in deck B stops temporarily.
Note: The PAUSE button only applies to deck B.
14
2. Press the <j or > button.
This restarts playback of the tape in deck B.
Changing the Playback Direction
1. To change the playback direction during playback, press the <j or
& button.
The other side of the tape wil! now play.
2. To change the playback direction without starting playback, press the
<i] or > button while also pressing the stop = button.
This allows you to set the tape direction for a timed recording.
Fast-Winding the Tape
Press the ««@ orf p® buttons on the Tape Deck to advance the tape rapidly
in the direction of the arrows.
Listening to Tape Continuously
You can set the tape deck up to play both sides of the tapes in decks A and
B repeatedly.
1. Insert cassettes into decks A and B.
2. Set the REV.MODE switch to <>
(auto reverse) position.
. MOE,
oer
non reverse ~
iC)
auto reverse
@
The tape deck wiil be placed in auto reverse mode, which means that
it will play all of one side of the tape and then ail of the other side.
3. Press the <i or > button of the deck to be started first.
®
Now both sides of both tapes will play repeatedly.
@ After playback in reverse direction ends, the playing deck (Aor B) will
be switched to the other deck.
@
if the tape deck is not placed in auto reverse mode, only one side of
the tapes in decks A and B will play continuously.
@
If you press the TAPE button on the Amplifier, deck 8 will start first.
Skipping Blanks
When there is a blank of 10 seconds or more, the tape skips forward to the
beginning of the next track.
1. Press
the BLANK
SKIP button on the tape deck.
NI
om
2. Press the <I or > button.
Blank Skip playback starts.
The BLANK SKIP function is not effective:
@ When the track contains an area of low sound level.
@
When the blank between tracks is short.
®
When there is noise, for exampie,
a hum between tracks.
Advertisement
Table of Contents
