Bosch PSR Select Original Instructions Manual page 15

Follow the instructions on correct disposal.
Inserting the screwdriver bits into the bit magazine (see
figures B–C)
wards.
Only insert one screwdriver bit per chamber into the bit magazine. Only
use short standard screwdriver bits. Longer screwdriver bits cannot be
loaded into the bit magazine.
Turn the bit magazine (11) until an empty chamber is visible in the viewing
window (3).
Push the sliding switch (7) forwards.
Insert the screwdriver bit (1) directly into the tool holder (2).
Push the sliding switch (7) backwards to load the screwdriver bit (1) into
the bit magazine (11).
Once you have pushed the sliding switch (7) backwards or pressed the on/
off switch (10) while it is in the rear position, the bit magazine (11) will be il-
luminated for approx. 20 seconds.
Changing the Tool (see figure D)
Wear safety goggles when changing the tool. Do not look directly into
the tool holder. When changing the application tool, there is a possibility
that it may be ejected outwards.
Turn the bit magazine (11) until the required screwdriver bit (1) is visible in
the viewing window (3).
Push the sliding switch (7) forwards.
Bosch Power Tools
Wear safety goggles when chan-
ging the tool. Do not look directly
into the tool holder. When changing
the application tool, there is a pos-
sibility that it may be ejected out-
1 609 92A 84N | (21.07.2022)
English | 31