Maintenance Schedule - Cub Cadet THE TANK S6031 Operator's And Service Manual

MAINTENANCE SCHEDULE

A. Daily Checks
1. Before starting engine:
a. Check the fuel level.**
b. Check the engine oil level.**
c. Check the hydraulic oil level.
d. Check the hydraulic hoses for leaks, abrasion,
kinks, twists, or a flattened condition.
e. Check the tires and tire pressure.
Drive Tires: 10-12 psi.
Front Wheels: 20-25 psi.
f. Check the spindle belt, the mower drive belt and
the hydro drive belt.
g. Check the blades. Make sure they are sharp and
that the blade securing cap screws are tight.
h. Check the cutting height.
2. When ready to start the engine:
a. Check the three safety switches for proper opera-
tion.
3. After mowing:
a. Clean the mower.
b. Clean the engine air screen.
c. Oil the wear points. Follow the Oiling Chart.
d. After the first five hours, Change the engine oil
and engine oil filter.
B. Every 25 Hour Checks
1. Service the engine foam element air precleaner.*
2. Grease the three spindle bearings.
C. Weekly or Every 50 Hour Checks
1. Change the engine oil. (Every 25 hours under heavy
duty operation.)
2. Clean or replace the engine's paper air cleaner ele-
ment.*
3. Check the battery's electrolyte level.
4. Clean the engine cooling fins and external surfaces.*
5. After the first 50 hours, change the hydraulic oil and
the hydraulic oil filter. Change them every 500 hours
thereafter. Use Shell Rimula 15W40 or equivalent
and add 1.5 ounces of ornite additive.
6. Oil wear points. Follow the Oiling Chart.
7. Lubricate all grease fittings. Follow the Lubrica-
tion Chart.
D. Every 100 Hour Checks
1. Change the engine oil filter. (Every 50 hours under
heavy duty operation.)
2. Check the engine spark plugs.
3. BBC (PTO Clutch) air gap should not exceed 0.025",
if so, adjust as follows: Ogura JD08, DX-11, GT-1A,
GT-2, GT-2.5, adjust to 0.012" - 0.015"
Ogura GT-3, GT3.5, adjust to 0.015" - 0.022"
E. Yearly Checks
1. Check the oil in the hydraulic reservoir.
Engine coolant:
Use only Shell Dex-cool, extended life anti-
freeze diluted with water to create a 50:50 mixture.
Hydraulic fluid:
Use Shell Rimula 15W40 oil and 1.5 ounces of
Ornite additive.
Engine Oil: Use Shell Rimula 15W40 oil.
Spindle Lubricant: Use only Shell Alvania RL 2 grease.
This grease is an amber-colored grease designed for high
speed bearing applications. It has a base oil viscosity that
reduces running losses, has been formulated for low noise,
has excellent corrosion protection, and has excellent bearing
lubrication.
General Purpose Lubrication: Use any NLGI grade 2
multi-purpose grease. Shell Albida EP2 is recommended.
Shell Albida EP 2 is a red-colored multi-purpose grease
designed for heavy-duty bearing applications. It has high
base oil viscosity for mechanical stability, has been formu-
lated for high load, low-speed applications, and has excellent
lubrication and corrosion protection.
* Perform maintenance more frequently under dusty condi-
**Reference Engine Owner's Manual
23
tions.