Table of Contents
Advertisement
(D REMOTE CONTROL Cable Connectors
|
Use these to connect compatible Yamaha components (with
an
25/8) mark) to your amplifier for remote control of each
component The cables jor each component are supplied
with the AVC-5C.
:
|
PHONO—Connect to a turntable using the cable with
a mini-olug connector.
TUNER—Connect
to a tuner using the cable with a
§-pin connector
TAPE—Connect to a cassette tape deck using the cable
with a 6-pin connector
@) Video Signal Connection Terminals
Use these to connect the video signal cables from your
components to :he amplifier They should be connected to
the proper input/output jacks for each unit.
TV¥—Connect a TV tuner here,
VDP—Connect a video disc player here,
VCR 1-—Connect a video recorder here for both
recording and playback.
VOR 2-—Connect a second video recorder here for both
recording and playback.
MONITOR OUT 1—Connect this to the video IN
terminal on a video monitor
MONITOR OUT 2—Connect this to the video IN
terminal on a second video monitor.
@® Audio Signal Connection Terminals
Use these to connect the audio signal cables from your
components to the amplifier They should be connected to
the proper input/output jacks for each unit. Be sure that L
and R channels are connected consistently.
PHONO—Connect a turntable here,
GND-—Connect the ground wire from a turntable here.
CD—Connect a compact disc player here.
|
TUNER—Connect a tuner here.
AUX--Connect another audio component here. A
turntable cannot be connected to these terminals.
TAPE 1—
TAPE 2—Connect a second audio tape deck here.
Connect a cassette tape deck.
TW Connea
a TV tuner here.
VDP-Connect a video disc player here.
VCR i—Connect a video cassette recorder here for
both recording and playback.
VCR 2—Connect a second video cassette recorder here
for both recording and playback.
@ OUTPUT Terminals
These terminals allow a number of system connecti ion
possibilities. The bars connecting the REAR and MAIN IN
terminals may be left as is, removed, or changed according
to the system connection configuration you select. See the
Connections section for a detailed explanation of how these
terminals are used for each system configuration,
®© BALANCE Control
Use this rotary control to cancurrentiy change the leit and
right output volume to the speaker terminals, from full left
(1), to balanced right and left (0), to full right (A).
(6) SPEAKER Connection Terminals
A pair of speakers can be connected here, See the
Connections portion of this manual for details on speaker
connections.
D AC Power Cord
Use this to connect the amplifier to an AC wall outlet.
(8) AC OUTLETS
Use these to connect the power cords from your
components to the amplifier.
The power to the three switched outlets is controlled by the
amplifiers power switch. They will supply power to any
camponent that is connected to them whenever the AVC-50
_ is turned on, whether by the front panelpower switch or by
the remote control power switch.
The power to the two unswitched outlets is not controlled by
the amplifier They will continually supply power to any unit
connected to them, therefore, units with clocks, such as
VCRs, should be connected here.
Note that the AC outlets are size-coded for polarity, so insert
plugs correctly.
Advertisement
Table of Contents
