Yamaha PF-500 Installation Manual page 6

4 Click [Next].
The window below enables you to select the search method.
5 Check the radio button to the left of "Search for the best driver for
your device. (Recommended)." Click [Next].
The window below enables you to select a location in which to
install the driver.
6 Check the "CD-ROM drive" box and uncheck all other items.
Click [Next].
n The system may ask you to insert a Windows CD-ROM while it
checks for the driver. Specify the USBdrv_ directory of the CD-
ROM drive (such as D:\USBdrv_\) and continue the installation.
n When using the Windows 98, specify the USBdrv_ directory of the
CD-ROM drive (such as D:\USBdrv_\) and continue the installa-
tion.
7 When the system detects the driver on the CD-ROM and is ready
for installation, it displays the following screen.
Make sure that the "YAMAHA USB MIDI Driver" is listed, and
click [Next]. The system starts the installation.
8 When the installation is complete, the following screen appears.
Click [Finish].
n Some computers may take about ten seconds to show this screen
after the installation is complete.
6 Accessory CD-ROM Installation Guide (PF-500)
Windows 98
Windows Me
The driver has been installed.
G Installing the driver on a Windows 2000 sys-
tem
1 Start the computer and use the "Administrator" account to log into
Windows 2000.
2 Select [My Computer | Control Panel | System | Hardware | Driver
Signing | File Signature Verification], and check the radio button
to the left of "Ignore -Install all files, regardless of file signature"
and click [OK].
3 Insert the included CD-ROM into the CD-ROM drive.
4 Make sure the POWER switch on the PF-500 is set to OFF and
use the USB cable to connect the USB terminal of the computer
(or the USB hub) to the USB terminal of the PF-500. When the
PF-500 is turned on, the computer automatically displays the
"Found New Hardware Wizard." Click [Next].
5 Check the radio button to the left of "Search for a suitable driver
for my device. (Recommended)." Click [Next].
The window that appears enables you to select a location in which
to install the driver.
6 Check the "CD-ROM drives" box and uncheck all other items.
Click [Next].
n The system may ask you to insert a Windows CD-ROM while it
checks for the driver. Specify the "USBdrv2k_" directory of the
CD-ROM drive (such as D:\USBdrv2k_\) and continue the instal-
lation.
7 When the installation is complete, the system displays "Complet-
ing the Found New Hardware Wizard." Click [Finish].
n Some computers may take about ten seconds to show this screen
after the installation is complete.
8 Restart the computer.
The driver has been installed.