Carrier 50AH024 Installation, Start-Up And Service Instructions Manual page 18

INSTALLATION
Carrier
50B
BA,BB,
BC024
A 1 If 6 TO 2jT 9
B = LONGEST DIMENSION OF OUTLET OPENING
NOTES--
I. TRANSFORMATIONS TO SUPPLY DUCT HAVE MAXIMUM SLOPE f IN
T
2 SQUARE ELBOWS WITH DOUBLE THICKNESS VANES MAY BE SUBSTITUTED
3 DO NOT INSTALL DUCTS SO THAT THE AIR FLOW IS COUNTER TO FAN .
ROTATION IF NECESSARY TURN FAN SECTION
4 TRANSFORMATIONS AND UNITS SHALL BE ADEQUATELY SUPPORTED SO NO
WEIGHT IS ON FLEXIBLE FAN CONNECTION
FIG. 12 - FAN DISCHARGE CONNECTIONS FOR MULTIPLE FAN UNITS
parallel to each other and located in the compressor
section. The condensers are shipped interconnected
to provide single inlet and outlet water connections
for cooling tower application.
Water connections may be made through the right
side panel. See dimension drawing for location. It
is not necessary to remove the panel. Each condens¬
er is provided with pipe connections for water inlet
and outlet as shown in Fig. 13.
TABLE 6 - CONDENSER DATA
Cond.
Inlet and
Size
Number Outlet
Unit
(Ton)
Required Sizes
50BA024
50BC024
10
2 2-1/2 FPT
PIPE NIPPLE
FIG. 13 - CONDENSERS SHIPPED FOR RECIRCULATING WATER
10