Kenwood KR-A5040 Instruction Manual page 9

M@ 75 Q coaxial cable connection (For U.K. and Europe)
@ Arrange the coaxial cable as @) Open the 75 0/300 © antenna (3) Cut off the wire and remove it
illustrate. adaptor. from the clip.
Outer shield Inner
conductor
AG-6 (5C-2V) or RG-59 (3C-2V)}
) Insert into the slit on the clip. Connect the adaptor to the an-
Fasten the bands A and B, us- tenna terminal.
ing a pair of pliers.
Ne a
FM DE-EMPHASIS/CHANNEL SPACE switch (Except for some areas)
The FM DE-EMPHASIS/CHANNEL SPACE switch on the rear )
panel is set to the correct setting that prevails in the area Area CHANNEL FM DE-
to which the unit is shipped. However, if the FM DE- _ SPAGE freq: | EMPHASIS
EMPHASIS/CHANNEL SPACE Setting is not matched to the n o k alkene,
area where ihe unit is to be used; for instance, when you U.S.A., Canada, FM: 100kHz~
moved from area 1 to area 2 or vice versa, desired recep- Hawaii, South AM: 10kKHz °
American countries
tion of AM/FM broadcasts is not expected. In this case,
change the FM DE-EMPHASIS/CHANNEL SPACE seiting in See ah
accordance with the area corresponding to the table. The 2. Other countries FM: SOkH2
FM DE-EMPHASIS is switched aver at the same time. AM: kHz
@ When changing the setting of the FM DE-EMPHASIS/
CHANNEL SPACE switch, first disconnect the power
cord of the amplifier, then reset the channel space
switch, connect the power cord again and turn the power
on while pressing the TUNER key.
FM DE-EMPHASS
CHANNEL SPACE
5O ps
FM 50 kHz
A AM SkHZ
75 es
FM 100kHz
AM TOkHz
KR-A5040 (Ea) 9