Kenwood KR-A5040 Instruction Manual page 15

TUNED indicator
(Lights when the station frequency is received.)
MEMORY indicator
Display section
kHz
runes MHz | 2 |
Frequency display
Direct tuning
This method allows the desired frequency to be entered directly
using the numeric keys, without using the TUNING key.
1. Press the DIRECT key. |
2. Enter the frequency of the desired station with the nu-
meric keys.
® When all of the digits of the frequency have been en-
tered, the station is automatically received.
@ if the entered frequency is not in the receivable frequency
range, the frequency display blinks for 5 seconds, and
the last station received is received again.
@ Preset tuning
By storing the frequencies of broadcasting stations in the preset
channels according to the instructions in the 'To preset sta-
tion frequencies"' section, any of the preset stations can be
received by one-touch operation.
Press the numeric key corresponding to the preset channel
of the desired station.
@ The display shows the frequency of that station, and the
station is received.
TAPE 2
MEMORY key
BAND selector key
Numeric (1 ~ 10/0) keys DIRECT key
P.CALL key
M To preset station frequencies
1. Press the BAND selector key for the desired band (FM1,
FM2 or AM).
2. Tune in the desired station following the instructions in
the *"'Tuning methods"' section.
3. Press the MEMORY key.
@ The indicator on the display lights.
4, Within 5 seconds after pressing the MEMORY key, press
the numeric key {1 to 10/0) corresponding to the preset
channel in which the frequency is to be stored.
® |f a frequency has already been stored under the select-
ed preset channel, the previously-stored frequency will
be replaced by the new frequency.
5. Preset all desired frequencies by repeating steps 1 to 4
above.
@ Preset Scan
This function allows the preset siations stored in the preset
channels to be received in sequence for 5 seconds each.
1. Press the P.CALL key.
@ The frequency of each preset station is received for 5
seconds in sequence. A preset channel in which no sta-
tion has been preset is skipped, and the scan operation
moves to the next preset channel.
2. To stop Preset Scan, press the P.CALL key again.
@ The preset station being received when the key is pressed
is received continuously.
KRB-A5040 (En) 15