Kenwood KR-A5040 Instruction Manual page 16

Remote control
@ Operations
1. Connect the power plug of the receiver to an AC outlet.
@ The receiver enters the power standby mode and the
POWER/STANDBY indicator lights.
2. Press the POWER key of the remote control unit or the
POWER switch of the receiver.
® The receiver enters the power ON mede.
3. The various functions of the receiver can be operated
with the keys of the remote control unit.
Note for remote control operation
After pressing one of the operation keys, when the next
operation is required, press the next operation key firm-
ly after an approx, 1 second interval.
If the next operation key is pressed immediately after the
previous key, misoperation may result.
Mf Installing the batteries in the remote control
unit
1. Remove the battery compartment cover.
2. Insert two size "AA" (R6) batteries confirming the cor-
rect polarity and close the cover in its place.
Note: --.—— =
The provided batteries are to be used for checking the operation
of the remote control unit, and they may have a short life. When
the remote control unit becomes effective only for short distances
or does not operate properly, replace the batteries with two new
batteries.
16 «R-A5040 (En}
H Operating range of the remote control unit
The operating range of the remote contro] unit may differ ac-
cording tc temperature, humidity, or using conditions, however,
it is defined approximately as shown in the figure below:
va <«—__-———--- REMOTE SENSOR of
the main unit
| Remote
control
unit
The signal transmission system used
by this remote control unit is the in-
frared control system.
Malfunction may occur in case direct sunlight or the light
of a high-frequency lighting fluorescent lamp enters ihe
remote control light recepter. In such a case, change the
installation position of the unit so that the malfunction
does not occur.
= q
Ft
i