Midi Functions; Midi Transmit/Receive Channel Selection; Local Control On/Off - Yamaha Clavinova CLP-110 Owner's Manual

MIDI Functions

You can make detailed adjustments to MIDI settings.
For more information about MIDI, see the "About MIDI" section (page 23).

MIDI Transmit/Receive Channel Selection

In any MIDI control setup, the MIDI channels of the transmitting and receiving equip-
ment must be matched for proper data transfer.
This parameter enables you to specify the channel on which the Clavinova transmits or
receives MIDI data.
Procedure
Setting the transmit channel
While holding down the A-1 and C 0 keys, press one of the C1–E2 keys.
Setting the receive channel
While holding down the A-1 and C 0 keys, press one of the C4–F5 keys.
A-1 C 0

Local Control ON/OFF

"Local Control" refers to the fact that, normally, the CLP-110 keyboard controls its
internal tone generator, allowing the internal voices to be played directly from the key-
board. This situation is "Local Control On," since the internal tone generator is con-
trolled locally by its own keyboard.
Local control can be turned OFF, however, so that the CLP-110 keyboard does not play
the internal voices, but the appropriate MIDI information is still transmitted via the
MIDI OUT connector when notes are played on the keyboard. At the same time, the
internal tone generator responds to MIDI information received via the MIDI IN con-
nector.
Procedure
While holding down the A-1 and C 0 keys, press the C6 key.
A-1 C 0
26

MIDI Functions

CLP-110
E2
C1 D 2
2 4 7 9 11 14 16
1 3 5 6 8 10 12 13 15
For setting the
transmit channels.
(C1–D 2)
OFF
E5
C4 F5
2 4 7 9 11 14 16
1 3 5 6 8 10 12 13 15 1+2
For setting the
receive channels.
(C4–F5)
For ALL mode
C6
The highest
key
NOTE
Demo and preset song data are
not transmitted via MIDI.
NOTE
In Dual mode, Voice 1 data is
transmitted on its specified
channel and Voice 2 data is
transmitted on the next greater
channel number relative to the
specified channel. In this mode,
no data is transmitted if the
transmit channel is set to "OFF."
TIP
ALL:
A "Multi-timbre" Receive mode
is available. It allows simulta-
neous reception of different
parts on all 16 MIDI channels,
enabling the Clavinova to play
multi-channel song data
received from a music computer
or sequencer.
1+2:
A "1+2" Receive mode is avail-
able. It allows simultaneous
reception on channels 1 and 2
only, enabling the Clavinova to
play 1 and 2 channel song data
received from a music computer
or sequencer.
TIP
Program change and other like
channel messages received will
not affect the CLP-110's panel
settings or the notes you play
on the keyboard.
NOTE
The Clavinova does not receive
MIDI data when it is in Demo or
Preset Song mode.