Yamaha YHT-900 Quick Connect Manual page 11

P T U
ROGRAMMING HE
S U Y C B
ETTING P OUR ABLE OX
1. Turn on the cable box (or DSS) and look up a setup
code for your brand of cable box (or DSS) (codes are
located at the back of the HTR-5560 Owner's Manual).
2. On the remote control, press D-TV/CBL.
CODE SET
POWER POWER
TV AV
CD MD/CD-R
DVD D - TV/CBL
VCR 1 VCR2/DVR
3. Press CODE SET using a ballpoint pen or similar
object. The TRANSMIT indicator LED will flash
twice.
4. Using the keypad, enter the four-digit setup code.
The indicator LED will flash twice after your entry.
If the LED did not flash twice, repeat steps 3 and 4.
5. To verify the code works, aim the remote control at
the cable box (or DSS), press D-TV/CBL, and then
press AV POWER . The unit should turn off. If it
doesn't respond, use another code for the same
manufacturer and repeat steps 3 through 5.
CODE SET
POWER POWER
TV AV
S U Y VCR
ETTING P OUR
1. Turn on the VCR and look up a setup code for your
brand of VCR.
2. On the remote control, press VCR 1.
CODE SET
POWER POWER
TV AV
CD MD/CD-R
D - TV/CBL
DVD
VCR 1 VCR2/DVR
3. Press CODE SET using a ballpoint pen or similar
object. The TRANSMIT indicator LED will flash
twice.
4. Using the keypad, enter the four-digit setup code.
The indicator LED will flash twice after your entry.
If the LED did not flash twice, repeat steps 3 and 4.
R C
NIVERSAL EMOTE
( DSS)
OR
TRANSMIT
SYSTEM
STANDBY POWER
TUNER SLEEP
V - AUX
6CH INPUT
A AMP
TRANSMIT
SYSTEM
STANDBY POWER
TRANSMIT
SYSTEM
STANDBY POWER
TUNER SLEEP
V - AUX
6CH INPUT
AMP
A
YHT-900 Q
(C )
ONTROL ONTINUED
5. To verify the code works, aim the remote control at
the VCR, press VCR 1, and then press AV POWER.
The VCR should turn off. If it doesn't respond, use
another code for the same manufacturer and repeat
steps 3 through 5.
S U O
ETTING P THER
1.
Turn on the component (e.g. CD player, tape deck,
or MD player) and look up a setup code for your
brand of component.
2. On the remote control, press the desired component
button (e.g., CD or MD/CD-R).
3. Press CODE SET using a ballpoint pen or similar
object. The TRANSMIT indicator LED will flash
twice.
4. Using the keypad, enter the four-digit setup code.
The indicator LED will flash twice after your entry.
If the LED did not flash twice, repeat steps 3 and 4.
To verify the code works, aim the remote control at the
5.
component, press the appropriate component button,
and then press AV POWER. The unit should turn off.
If it doesn't respond, use another code for the same
manufacturer and repeat steps 3 through 5.
NOTE: Your component's original remote control must have a
power On/Off function in order for this remote to control your
component's power function.
-C
U I C K O N N E C T
C
OMPONENTS
CODE SET TRANSMIT
SYSTEM
POWER POWER STANDBY POWER
TV
AV
G
U I D E
11