Pioneer PD-DM802 Operating Instructions Manual

Operating
Instructions
Ci,
PD-DM902
MULTI-PLAY COMPACT DISC PLAYER
PLD-DM8&02
PD-DM902
_ DIGITAL AUDIO
PD-DM802
Demo mode allows you to see variations of
the display. To enter the demo mode, press
POWER and then t<¢ <q within 1 second
DEMO MODE}
without inserting a magazine. To exit demo
mode, insert the magazine or press any button.
Thank you for buying this Pioneer product.
Please read through these operating instructions so you
will know how to operate your model properly. After you
have finished reading the instructions, put them away in a
safe place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown in
the explanatory drawings. However, the method of
connecting and operating the unit is the same.
WARNING: To PREVENT FIRE OR SHOCK HAZARD, DO
NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
IMPORTANT NOTICE
The serial number for this equipment is located on the rear
panel. Please write this serial number on your enclosed
warranty card and keep it in a secure area. This is for your
security.
[For Canadian model]
CAUTION: To PREVENT ELECTRIC SHOCK DO NOT USE
THIS (POLARIZED) PLUG WITH AN EXTENSION CORD,
RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN
BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.
ATTENTION: pour PREVENIR LES CHOCS ELECTRIQUES
NE PAS UTILISER CETTE FICHE POLARISEE AVEC UN
PROLONGATEUR, UNE PRISE DE COURANT OU UNE AUTRE
SORTIE DE COURANT, SAUF SI LES LAMES PEUVENT ETRE
INSEREES A FOND SANS EN LAISSER AUCUNE PARTIE A
DECOUVERT.
LINE VOLTAGE SELECTOR SWITCH
Only muiti-voltage models are provided with this switch.
U.S., and Australian models are not provided with this
switch.
Mains voltages in Saudi Arabia are 127V and 220V only.
Never use this model with 110V setting in Saudi Arabia.
The line voltage selector switch is located on the rear panel of this
player. Before your player is shipped from the factory, the switch is
set to the power requirements of the player's destination. Check that
itis set properly before plugging the power cord into the outlet. If the
voltage is not properly set or if you move to an area where the voltage
requirements differ, adjust the selector switch as follows:
@ Use a medium-sized (flat blade) screwdriver. Insest the tip of the
screwdriver into the groove of the selector switch and turn it so
that the power voltage marking of your area points to the arrow.
VOLTAGE SELECTOR
u
tov
4
BS"
Tae,
fay ©
@ PIONEER'
The Art of Entertainment