Table of Contents
Advertisement
An alternate method of programming repeater data
(this method
allows you to have a tone in the Temporary Memory)
is this.
a Memory channel
that has
the Tone and preferably the
Frequency Shift that you require.
Then while the PCS-9600D
is
that Memory Channel,
copy the data
into Temporary memory by
pressing the F Key #4,
and immediately pressing the TM
(WR)
Key
#9.
Since the
frequency copied is not the frequency that you
require
(you only wanted the tone and the Shift),
use the Up and
Down keys to set the correct receive
frequency.
Momentarily touch the PTT Button on the microphone and watch
the screen to observe the Transmit frequency.
If the shift is
correct,
you then have the Receive and Transmit frequencies plus
the Tone programed
into temporary memory.
If the shift
is
in
the wrong direction use the F Key #4,and then the Shift Key,
#10
to
reverse the direction.
5)
Recalling Temporary Memory
The Temporary Memory can be recalled while the unit
is
in either
the Direct or The Memory Channel mode.
Simply press the TM
(WR)
/
#8
(do not press F Key)
and the Temporary Memory will
appear on screen ready to use.
Press
the TM
(WR)
key again and
the unit will
return to the
frequency or memory channel where
it
was before.
This
easy access to Temporary Memory can be very
useful.
J)
MEMORY SCANNTWfi
To
initiate memory scanning,
press
the SCAN Key #11,
while
the
mit
is
in the memory mode.
The scan will begin with the next
channel
above the
channel
shown on the
screen.
Memory scanning will
only occur
in the Memory Bank displayed
on the screen.
If Bank B
is displayed only Bank B will
be
scanned.
If A and B are displayed then all
20 memory channels will
be
scanned.
K)
Programmable Band
Scanning
When
in the Direct Mode,
the unit will
scan between any two
frequencies designated.
Memory channel A8
should be used to
store the
lower
limit frequency for the band scan.
Channel A9
should be used to store the high limit
for the scan.
Another
set of
limits
can be stored in B8
and B9.
If Bank A is
shown on the screen the
frequencies between A8
and
A9 will be scanned.
If Bank B is
shown on the screen the unit
will
scan between the frequencies
shown on B8
and B9.
If Banks A and B are shown on the screen the unit will
scan both
bands of
frequencies.
L)
Stopping the Scan
Memory Scanning or Band Scanning can be stopped at any time by
pressing any one of the following keys.
Microphone PTT,
Up,
Down,
TM,
REV,
M MODE,
or F.
the PTT Button
is used to stop the
scan,
push the button a
16
Advertisement
Table of Contents
